I actually just did this over the weekend.
Yes, I created a profile with 2 steps:
First step (Wait):
- Step Type: Heat/Cool to target temperature
- Target Temperature: 55 degF
- Go to next step when: the step timer is finished
- Start the step timer: as soon as the step starts
-...
I haven’t gotten around to switching out the lines yet but I picked up one of these Duotight flow control QD’s and was going to try it with the 4mm ID line to see if I could go even shorter in my kegerator
I’ve been putting this off for exactly this reason. I do have a pipe bender from when I built a wort chiller but I haven’t figured out the best way to measure the 11 degree bend MoreBeer recommends 🤣
I’ve experimented with sparge and no-sparge on my Gen4 BrewZilla. The no-sparge was definitely simpler, but my efficiency was abysmal. I’m sure with more experimentation I could bring it up, but the obvious balance to the lower efficiency is more grain, and for a lot of the stuff I’m doing for a...
So are you using PID and the BT probe together? The Kegland video on the two seems to suggest it’s either-or and I’ve seen a lot of people say they turned off PID once they added the probe but it seems to me like both together gets you a more accurate temperate and prevents overshoots. I tested...
Sorry I just saw this! All is well; I didn’t think about the fact that the center screw would sit in the center drain, so inside the unit itself everything sits correctly.
I threw another washer between the wing nut and the HED just to disperse the tension a bit BUT at around 5:30 this morning I had the realization that once inside the unit, the longer screw sits in the center drain and so the off-balance I mentioned when placing it on the table after assembly...